Page 7
522155
MARK V MODEL 505/510 ROUTER TABLE
CARE AND MAINTENANCE OF
ROUTER BITS
You will enjoy longer use of your router bits if
you make it a point to handle, use and sharpen
them properly.
• Use your router bits only for the job they are
intended to do.
• Make sure the bit is mounted rigidly in the
collet.
• Learn to cut your workpiece at the proper
speed to prevent heat buildup that can
cause burning wood and reduce cutter life.
• Between operations, set your bits in a safe
place where they will not fall or get hit.
CAUTION
Never use solvent on a bearing-piloted bit without
first removing the bearing.
• After use, clean bits thoroughly.
• Sharpen your bits with a small slip stone
or oil stone with oil. Hone the flat face of
each cutter with light strokes in one di-
rection. Never hone the outside edge be-
cause it reduces the diameter of the cut-
ter. Hone the face and each cutter with
the same number of strokes.
• If the cutting edge is nicked, take the bit
to a professional sharpening servi
ce.
TOOLS NEEDED
In addition to the tools provided with your
MARK V Model 505/510 Router Table you
will need the following from your MARK V
Setup. See your owners’ information for part
numbers, views, and descriptions of these items.
5/32” Allen Wrench
Connector Tubes (2)
T-Joint (2)
Telescoping Legs (2)
ASSEMBLY
WARNING
Make sure the Speed Dial is set to "Slow",
then turn off and unplug the MARK V before
performing any ASSEMBLY procedure.
1.
With your MARK V setup in the Horizon-
tal Position, remove all Accessories, leav-
ing only the Main Saw Table Assembly in
the Carriage Assembly. Adjust the Saw
Table to a comfortable height.
2.
Loosen both the Headstock and Carriage
Locks. Slide the Headstock to the left and
the Carriage to the right, as far as they
will go. Lock into position.
3.
Place the Router Table facedown on a
clean, flat shop table or bench. Locate the
package containing the Router Plate and
assemble the Brackets ONLY, according
to the included instructions. (Figure 1)
Figure 1
4.
Insert one Connector Tube into both the
Front and Rear Table Tubes (3) of the
Router Table.
