8/18/2004
17
Battery Charging Procedure
There are two ways to charge the Jiffy portable Powerchair:
1) Plug the A/C power cord into the wall. Plug the male three-pin
charger plug into the female 3-pin receiver located on the
bottom of the VSI (Refer to Figure 2, #8).
2) Remove the battery-pack from the unit. Plug the A/C power
cord into the wall. Located on the battery-pack is a charger port.
Slide the charger port cover over to expose the charger female
3-pin receiver. Plug the male three-pin charger plug into the
female 3-pin receiver. It is not necessary for the battery-pack to
be attached to the Powerchair to charge.
The battery charger’s light indicator is as follows:
Red -
Charging
Green -
Charging complete
Depending on the amount of battery discharge, the charge time can
take up to 12 hours. The battery charger has an electronic switch that
will terminate the charge when the batteries are fully charged. Do not
remove the battery charger until the charging cycle is complete. Be
sure to unplug charger from the wall first before unplugging charger
from the Powerchair.
WARNING! Only use the original manufacturer approved
charger!
This charger is for indoor use only. Do not expose it to rain or
water spray.
Do not leave the charger plugged into the Charging Port if the
charger is not charging.
