8
Shoprider Scooters User Guide
a built in charger port on the rear side of the battery pack. This special feature allows the
batteries within the battery pack to be charged without the scooter.
First Time Use
Prior to using your TE-GK9 Portable scooter for the first time, you must charge the batteries
fully (refer to Battery Charging Procedures). Charging may take up to 12 hours. Charging the
batteries completely prior to first time use will benefit battery efficiency. Failure to do so may
cause damage.
Charging
To charge the batteries connect the 3-pin male plug lead into the 3-pin female battery
charging socket located on the battery pack. Plug the A/C cord plug into the wall socket
and the other end into the charger (2-pin). The battery charger has two indicator lights. The
red light shows the batteries are charging. When the light turns green while connected to
the charging port the batteries are fully charged. Once the batteries are completely charged,
unplug the A/C cord from the wall then unplug the 3-pin lead from the battery pack. Remove
charger once charging cycle is finished.
WARNING: Only use the original Shoprider approved charger!
This charger is for indoor use only. DO NOT expose it to rain or water spray.
Do not leave the charger plugged into the charger port if the charger is not charging.
10. TRANSPORT / STORAGE
The TE-GK9 Portable scooter is designed to be quickly and easily disassembled into sections
for transportation and storage. Follow these simple guidelines for disassembly:
TE-GK9 Disassembly (Fig 10 - 13)
1) Remove the front basket: Lift basket up and off.
(Fig 10)
2) Fold the seat down and remove: Pull yellow seat lever up and lift seat up and off.
(Fig 11)
3) Remove battery pack: Lift battery pack up and off using handle (Note: battery pack may
be removed in 2 parts).
(Fig 12)
4) Fold tiller down and lock into place: Loosen tiller adjustment knob, lower tiller, and
tighten adjustment knob. Lock tiller assembly so that it doesn’t swing sideways by pulling
yellow tiller lock lever up and to the right.
(Fig 13)
5) Detach rear section from front section: Detach lever is located in the rear of the scooter next
to the freewheel lever. Slide lever to “detach” and separate rear section from front section.
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Rear section
removal lever
Seat release
handle
Tiller angle
adjustment
Tiller lock
lever
