Shopify MotoMask PRO, Руководство пользователя

Страница: 8 / 36

MASKING ROLLER ASSEMBLY
(only applicable for divided rollers, <3m rollers are pre-assembled)
7
Required tools for the installation.
• Fabric for the masking roller (supplied)
• 3M double sided tape (supplied)
• Cross screwdriver (supplied)
Step 1: Connect the divided roller.
• Most of the parts required for connecting the masking roller is already pre-installed.
• Align the two parts, slide the parts together and then secure them with the included screws.
Sliding the two parts together can sometimes be a bit tricky as the spacing is very tight
(it has to be to ensure sufficient rigidity). If needed, please use a rubber hammer
or a similar device to help sliding the parts together.
Drawing 4-1
Step 2: Connect the divided bottom bar.
• The connection parts are already fixed.
• Insert the connecting piece into the other lower bar part and then tighten the screw to complete
the connection of the divided bar. (Note: the screw used for securing the bottom bar must be
facing the back (i.e. not the audience) of the screen.)
This side
has been fixed
1
Connection
parts
2
2
Drawing 4-2
M4*6 screws
Step 3: Fixing the masking fabric to the roller.
1. Please make sure you find a clean and sufficiently sized area to perform the installation.
Connection parts
M6*10 Screws
These parts are pre-fixed
1
1
1
1
2
2
2
2