Changing the direction of the motor
Changing the direction of the motor is only required if set incorrectly
to begin with, or if the masking roller was attached the wrong way.
Normally this setting should not be used.
Press and hold the settings button
on the motor for 6 seconds,
followed by 3 beeps indicating
the altered direction.
Beep sound × 3
OK
The motor changes
direction successfully
Clearing the 3. limit point
Stop button × 1
Stop button × 1
P2 × 1
Power On
OK
Setting finished
Beep sound × 1
Beep sound × 1
Beep sound × 3
Rotation indication
Please stop the masking
fabric at the 3. point by
holding the "STOP" button
for 3 seconds
Setting the Cinescope masking
point (3. limit)
The 3. limit point is set after the upper and lower limits are set. The the upper point is used for 16:9
and the lower point is used to close the masking on a 16:9 native screen, the 3rd point is set to change
the aspect ratio from 16:9 to 2.40:1. For the 2.40:1 native screens and the 2-way masking systems only
the upper (2.40:1) and lower (16:9) limits is set.
Please note that resetting the upper and lower limits will also reset the 3. limit point.
1
2
After setting the 3. point you can easily recall it by holding the "STOP" button for 3 seconds.
4
Stop button × 1
Stop button × 1
Stop button × 1
OK
3rd limit setting finished
P2 × 1
Beep sound × 1
Beep sound × 1
Beep sound × 3
Rotation indication
Motor stop running
Use the up/down buttons to adjust
the masking fabric to your preferred
3. limit point (the cinescope 2.40:1
masking point).
First set the upper
and lower limits
For additional precision in adjusting, you can enter the "micro step" mode by pressing the P2-button WHILE
the motor is moving either up or down. The exit the "micro step" mode, please press the P2 button again.
3
Deleting the settings
Following this procedure will delete all memories!
Stop button × 1
P2 × 1
P2 × 1
OK
All settings deleted successfully
Beep sound × 1
Beep sound × 1
Beep sound × 3
Rotation indication
Down button × 1
P2 × 1
P2 × 1
OK
Clearing limit setting finished
Beep sound × 1
Beep sound × 1
Beep sound × 3
Rotation indication
Clearing the Limit Setting
Use this setting if you would only like to clear the limits. Please note that clearing the limits
will remove both the upper, lower and the 3rd (masking) point (if set).
34
Содержание MotoMask PRO
Страница 1: ...USER S MANUAL ...
Страница 20: ...19 Drawing 5 6 4 L shape connection part 1 Preinstalled metal 2 Drawing 5 6 3 U shape connection part 1 ...
Страница 24: ...23 Drawing 6 1 1 Upper bracket Lower bracket M6x20 screws M6 12 screws ...
Страница 27: ...26 Step 3 Remove the remaining upper connection parts Drawing 5 3 2 1 1 2 2 Drawing 5 3 1 ...