Desktop Quick Start Guide • October 6, 2017
© Copyright 2017 ShopBot Tools, Inc.
page 15
Use the included wrenches to fully tighten nut.
Over-tightening will make collet difficult to remove and may
damage it. Under-tightening will allow the bit to slip during
operation.
A firm one-hand squeeze is usually sufficient - a torque of
approximately 59 ft-lbs.
Go to www.shopbottools.com, then click on the ShopBot Docs link at the center
of the top of the main page. Then click on your tool (either Desktop or Desktop
MAX).
Scroll to the bottom of the page under the “Files” heading and download the
machine setup files (either “DT MAX Machine setup Files” or “Desktop Machine
setup Files”).
Open the zipped folder containing the setup (DT MAX only) and squaring .sbp file.
These files will set the MAX proximity switch offsets (for MAX tools only, not necessary for Desktop),
then run a squaring program, which will run the gantry until hits the end to make sure the gantry is
square with the tool. The motors will sound like they are grinding, but in actuality, this is NOT damag-
ing the machine, nor is it causing any shortage of product lifespan.
Open zipped folder and copy the files to a convenient location.
Ensure Desktop is connected to computer and powered on. Start SB3,
the press “Cut Part” button.
Stand clear of the tool when it is in
motion, preferably standing near the
computer that is controlling the tool’s
operation. A ShopBot is a very safe
power tool as long as safety procedures
are followed.
