PAGE 11
EMPTYING LIQUID WASTE FROM THE TANK
To empty liquid waste from the tank, turn the vacuum off and remove the plug from the wall outlet. Remove
the drain cap and deposit the liquid waste in a suitable drain. Use side carry handles for lifting vac when
draining tank into drains that are located above floor level. After the tank is empty, return the drain cap to
it’s original position.
AUTOMATIC SUCTION SHUT OFF
The vacuum is equipped with an automatic suction shut-off that operates when picking up liquids. As the
level of the liquid rises in the tank, an internal float rises until it seats itself against a seal at the intake of
the motor, shutting off suction. When this happens, the motor will develop a higher than normal pitch noise
and the suction is drastically reduced. If this occurs, turn unit off immediately. Failure to turn unit off after
float rises and shuts off suction will result in extensive damage to the motor. To continue use, empty the
liquid waste from the tank as outlined in the previous section.
NOTE:
IF ACCIDENTALLY TIPPED OVER, THE VACUUM COULD LOSE SUCTION, IF THIS OCCURS, TURN UNIT
OFF AND PLACE VAC IN UPRIGHT POSITION. THIS WILL ALLOW THE FLOAT TO RETURN TO ITS NORMAL
POSITION AND YOU WILL BE ABLE TO CONTINUE OPERATION.
LUBRICATION
No lubrication is necessary as the motor is equipped with lifetime lubricated bearings.
STORAGE
Before storing your vacuum the tank should be emptied and cleaned. Never allow liquids
to sit in the tank for any extended period of time. The power cord can be wrapped around
the cord wraps provided on the tank cover on rear of unit. Accessories may be stored in the
tool holder (not standard on all models) so they can be readily available. The vacuum should
be stored indoors.
SERVICE
Do not attempt to service your Shop-Vac
®
wet/dry vacuum cleaner beyond that described in this manual.
Refer all other servicing to a qualified service center.
