PAGE 6 OF 8
0719 IH-8095
ACCESSORIES, HOSES AND WANDS
NOZZLES AND ACCESSORIES
All friction fit accessories - Insert wand end or hose into
accessory and twist to form a tight fit. (See Figure 16)
Wet/Dry Floor Nozzle
Crevice Tool
Claw Utility Nozzle
Figure 16
HOSES
Lock-On
®
Hoses - Insert hose collar onto threaded tank
inlet and tighten. (See Figure 17)
Figure 17
WANDS
Friction fit wands - Insert wand ends together and twist
to form a tight fit. (See Figure 18)
Figure 18
AUTOMATIC SHUTOFF
The vacuum cleaner is equipped with an automatic
shutoff that operates when picking up liquids. When the
liquid in the tank reaches a certain level, an internal
float will seat itself against a seal at the intake of the
motor, shutting off suction. When this happens, the
motor will develop a higher than normal pitch noise
indicating that you need to shut off the vacuum and
empty the liquid.
NOTE: If accidentally tipped over, the float
shutoff device could seat against the seal and
shut off suction. If this happens, simply place
the vacuum cleaner in upright position and
turn off the switch until the float returns to its
normal position.
EMPTYING THE TANK
CAUTION: Use special care when emptying
heavily loaded tanks.
The wet/dry vacuum may be emptied of liquid waste
by removing the tank cover. To empty, switch off the
vacuum and remove the plug from the wall receptacle.
Remove the tank cover and empty the tank.
NOTE: Tank can also be emptied by removing
drain cap and draining liquid waste into a
suitable drain.
STORAGE
Before storing the vacuum cleaner, always empty and
clean the tank. Never allow liquids to sit in the tank for
any extended period of time.
NOTE: Always store the vacuum cleaner indoors.
LUBRICATION
No lubrication is necessary as the motor is equipped
with lifetime lubricated bearings.
MAINTENANCE
WARNING: Be sure to disconnect power supply
before attempting to service or remove any
components.
SERVICE
Do not attempt to service your Shop-Vac
®
wet/dry vacuum
cleaner beyond that described in these instructions.
Refer all other servicing to Uline Customer Service.
WARNING: If any of the motor housing parts
should become detached or broken, exposing
the motor or any other electrical components,
operation should be discontinued immediately
to avoid personal injury or further damage to
the vacuum. Repairs should be made before
reusing the vacuum.
OPERATION CONTINUED
