PAGE 3 OF 8
0719 IH-8095
REAR CASTER ACCESSORY CADDY AND FRONT
CASTER FEET ASSEMBLY
1. With cord disconnected from receptacle and tank
cover removed, turn tank upside down so bottom is
facing up. (See Figure 2)
2. Take accessory caddy and place into slots (on rear
of tank opposite of drain). Secure with screws and
washers provided. (See Figure 2)
3. With tank drain facing you, take caster foot marked
with the letter A and place in slot on left side of tank
also marked with the letter A. (See Figure 3)
4. Secure with screw provided. (See Figure 4)
5. Take caster foot marked with the letter B and place
in slot on right side of tank also marked with the
letter B. (See Figure 5)
6. Secure with screw provided. (See Figure 6)
7. Install casters into caster feet by inserting caster
stems into holes provided. Apply pressure and
twisting motion until casters snap into place.
(See Figure 7)
8. Install casters into accessory caddy by inserting
caster stems into holes provided. Apply pressure and
twisting motion until casters snap into place.
(See Figure 8)
1. Remove vacuum cleaner and all accessories from
the carton.
2. IMPORTANT: Open tank cover by pushing latches
or clamps outward with thumbs and remove any
accessories that may have been shipped in the tank.
3. Assemble caster system following the instructions
below.
4. Depending on dry pick-up or wet pick-up operation,
install proper filter. (See page 4 for filter guide)
5. Replace cover and make sure latches or clamps
are secured over raised area of tank cover.
UNPACKING
ASSEMBLY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
A
