TOOL HOLDER ASSEMBLY
•
NOT STANDARD WITH ALL MODELS
1. With rear of unit facing you, take tool holder and position it with
tabs facing rear of unit
(Figure 8)
.
2. Place “J” shaped tabs into the slots on cord wraps
(Figure 9)
.
3. Press down until tabs snap into place.
4. Press down on center of tool holder until tab latches on bottom
of lid
(Figure 10)
.
POWER BLOWER OPERATION
BLOWER SAFETY
1. Never operate the portable blower in wet or damp conditions. Do not use in rain.
2. Keep area of operation clear of all persons, particularly small children and pets.
3. Dress properly. Do not wear loose clothing or jewelry. Always wear substantial footwear and long pants. Secure loose hair with a hat or hair
net to avoid hair being caught in moving parts.
4. Never blow debris in direction of bystanders.
5. Do not overreach or use blower from unstable surface such as ladders, trees, steep slopes, roof tops, etc. Always be sure of your footing.
6. Inspect the area before using the blower. Remove all debris and hard objects such as rocks, glass, wire, etc. that can be blown or cause
damage during operation.
7. Always wear a respirator or face mask when working in dusty environments.
8. Keep vents clean and clear of dirt and debris.
ASSEMBLY INSTRUCTIONS
1. To remove portable blower from tank cover, grasp both blower handles and pull in an upward motion
(Figure 11)
.
2. Insert 2 ½” extension wand into the blower exhaust. Push firmly into place by twisting wand slightly.
3. Attach desired accessory
(Figure 12)
.
4. Plug the cord into an electrical outlet. Your portable blower is ready for use.
Note:
If an extension cord is used, use only an approved outdoor
extension cord. To prevent extension cord from pulling away from appliance cord, tie cords as shown
(Figure 13)
.
5. To clean inlet shield and foam pad, disconnect cord from receptacle and remove screws on bottom side of power unit
(Figure 14)
.
6. Once removed, run foam pad under running water and blot with a clean towel to dry.
7. After cleaning, replace inlet shield and foam pad and secure with screws.
NOTE:
Inlet shield will only fit properly one way
(Figure 15)
.
CAUTION -
DO NOT OPERATE BLOWER WITHOUT INLET SHIELD AND FOAM PAD IN PLACE.
Extension
Cord
Appliance
Cord
BLOWER OPERATION
1. The correct operating position is to hold the portable blower in either hand, at arms length at your side. Your portable blower has been
designed with the necessary angle to direct the air blast toward the ground in front of you
(Figure 16)
.
2. Always work going away from solid objects such as walls, large stones, automobiles and fences.
3. Clean spaces with corners by starting in corners and moving outward to open areas to prevent an accumulation of debris which could fly into
your face.
4. Be careful when working near valuable plants. The force of the air could damage tender plants.
5. Use both handles when working above the waist or when two-handed grip is desired.
6. Your portable blower can be used for:
8
9
10
11
12
13
14
15
A. Cleaning grass from walkways
after mowing or edging
B. Sweeping or drying patios
C. Cleaning driveways
D. Sweeping out garages
and workshops
E. Blowing out flower beds
F. Leaf control in autumn
G. Cobweb removal
H. Overhead sweeping
I. Dusting of hard-to-clean equipment
J. Cleaning shelves and workbenches
