PAGE 5
ASSEMBLY
CASTER SYSTEM
Follow the instructions for the caster system that came with your vacuum.
PLASTIC TANK WITh REAR CASTER BASKET
You will find four casters, two caster feet, one basket and four screws with your wet/dry
vacuum.
1. With cord disconnected from receptacle and tank cover removed, turn
tank upside down so that the bottom is facing up.
2. Take basket and place into slots (on rear of tank opposite of drain). Secure with
screws provided.
3. With tank drain facing you, take caster foot marked with the letter A and
place in slot on left side of tank also marked with the letter A. Secure with
screw provided.
4. Take caster foot marked with the letter B and place in slot on right side of
tank also marked with the letter B. Secure with screw provided.
5. If flat washers are included in hardware package place flat washer over stem of caster before installing
casters into feet or basket.
NOTE:
Flat washers are not required with all units.
6. Install casters into caster feet and basket by inserting the
caster stems into the holes provided. Apply pressure and
twisting motion until caster snaps into place.
PLASTIC TANK WITh REAR WhEEL BASKET
You will find two casters, two caster feet, two rear wheels, one axle, one basket and four screws
with your vacuum.
Assemble as follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down so
that bottom is facing up.
2. Stand axle upright on hard surface and hammer on one cap nut.
3. Place one wheel on axle and slide down to cap nut. Be sure flat side of wheel hub is
facing outward.
Caster
Foot
Screw
Caster
Foot
Screw
Caster
Caster
Foot
