Shop fox SHOP FOX W1740, Руководство пользователя

Страница: 40 / 60

-38-
Model W1740 (For Machines Mfg. Since 1/13)
SE
RV
IC
E
11. Mark the top of the table lift screws with arrows (all
pointing in same direction) and mark the screws with
liquid correction fluid above the mounting bracket
( Figure.50 ). Later, when you reassemble the convey-
or table, you can use these marks to reset the table
height close to the current position.
12. Mark the chain and sprockets with correction fluid.
13.
Loosen the chain tension sprocket, carefully pull the
chain off of all the sprockets, and remove it from
the cabinet.
14.
Keeping track of the number of turns for later reas-
sembly, loosen the conveyor belt at the front adjust-
ment bolts, as shown in Figure.51.
15.
Disconnect the conveyor feed motor wires from the
circuit board.
16. Remove the scale pointer.
Before removing the table, note the number and location
of brass shims ( Figure.52 ) under the table lift screws.
Knowing their correct position will help you align the con-
veyor table during reassembly.
Figure.50. Locations to mark lift screws.
Figure.51.
Conveyor belt loosened at the
front adjustment bolts.
Figure.52.
Brass shim locations.
Continued on next page
Brass
Shims