Shop fox M1116, Руководство пользователя

Страница: 27 / 52

-25-
Model M1116 (For Machines Mfd. Since 06/17)
O
PE
R
ATIO
NS
Installing/Removing.
Tooling
Installing.Tooling
Model M1116 includes a 1–13mm drill chuck with an R8
arbor (see
Figure 23
).
3. Align tool slot (see Figure 25 ) with pin inside
spindle, then insert tooling into spindle until in
contacts drawbar.
Note: Height of drawbar inside spindle can be
changed by rotating adjustment nut (see
Figure 25
).
4. From above, thread drawbar by hand into tooling.
5. Secure spindle with spindle pin and tighten drawbar
with wrench, as shown in
Figure 25
.
Note: DO NOT overtighten drawbar.
6. Re-install drawbar cap.
Figure 23 . 1–13mm drill chuck joined with
R8 arbor.
Tool Slot
Drawbar Cap
Figure 24 . Location of drawbar cap.
Figure 25 . Components used when
installing or removing tooling.
Drawbar
Adjustment
Nut
Drawbar
Spindle Pin
Removing.Tooling
To remove tooling, do these steps:
1. DISCONNECT MACHINE FROM POWER!
2. Remove drawbar cap and secure spindle with spindle
pin, as shown in Figure 25 . Unthread drawbar from
tooling one full rotation.
Note: DO NOT fully unthread tooling from drawbar
or the drawbar and tool threads could be damaged
in the next step.
3. Tap top of drawbar with brass hammer to unseat
taper.
4. Hold tooling with one hand and unthread drawbar.
Cutting tools are sharp and can easily
cause cutting injuries. Always protect
your hands with leather gloves or
shop rags when handling cutting tools.
Tools Needed . Qty
Spindle Pin .......................................................1
Wrench 8mm .....................................................1
Brass Hammer ...................................................1
To install tooling, do these steps:
1. DISCONNECT MACHINE FROM POWER!
2. Remove drawbar cap (see Figure 24 ).