SHM IVFMV18LP, Руководство владельца по эксплуатации и установке

Страница: 19 / 28

19
INSPECTING BURNERS
Check pilot flame pattern and burner patterns
PILOT FLAME PATTERN
Figure 17 shows a correct pilot ame pattern.
Figure 18 shows an incorrect pilot
pattern.
The incorrect pilot flame is not touching the
thermocouple. This will cause the thermocouple
to cool. When the thermocouple cools, the heater
will shut down.
If pilot ame pattern is incorrect, as shown in
Figure 18:
Pilot Burner
Thermocouple
Pilot Burner
Thermocouple
Figure 17 - Correct Pilot Flame Pattern
(Your pilot may vary from pilots shown)
Figure 18 - Incorrect Pilot Flame Pattern
(Your pilot may vary from pilots shown)
turn Gas Log Set off (see Turning OFF the Ap-
pliance page 15)
Note: The pilot on natural gas units will
have a slight curve, but should be blue and
have no yellow or orange color.
•
see Cleaning and Maintenance, this page
Periodically inspect all burner ame holes with the
heater running. All slotted burner ame holes should
be open with yellow ame present. All round burner
ame holes should be open with a small blue ame
present. Some burner ame holes may become
blocked by debris or rust, with no ame present. If
so, turn off heater and let cool. Remove blockage.
Blocked burner ame holes will create soot.
MAIN BURNER
BURNER FLAME PATTERN
Figure 19 shows the correct burner flame patern.
Figure 20 shows the incorrect burner flame patern
.
turn Gas Log Set off (see Turning OFF the Ap-
pliance page 15)
•
•
see Cleaning and Maintenance, this page
• see Troubleshooting, page 22
•
CLEANING AND MAINTENANCE
WARNING: Turn off Gas Logs and let
CAUTION: keep burner and control
ding material, etc.
WARNING: Failure to keep the primary air op-
everything cool before cleaning.
fore each use. Have heater inspect ed year-
ening of the burner clean may result in sooting and
Burner
Tube
Injector Holder (May
Be Brass or Aluminum
Depending on Model)
Primary Air Inlet Hole
(Shape and size of
holes may vary by model)
o
compartment clean. See installation and
operating instructions accompanying the
heater.
Inspect these areas of heater be-
ly by a service person. Heater
may need more frequent cleaning due to
excessive lint from carpeting, pet hair, bed-
property damage.
The correct burner flame pattern shows yellow tip-
ping at the top of a large blue flame. If burner flame
is incorrect, as shown in
figure 20:
Continued
Figure 19 - Correct Burner Flame Pattern
Showing Blue Fame With Yellow/White Tips
Figure 20 - Inorrect Burner Flame Pattern
Showing SolidYellow/Orange Flame
often.