14
Operation
Adjust the Angle of Main Unit
• To avoid severe burns and electrical shock, do not adjust the angle of the main unit while the
heater is plugged in, operating, or hot.
• To avoid major burn injury, be sure to take hold of the burner grip when setting the angle of the
main unit.
Prior to operation, loosen the knob bolt to move and
set the main heater unit at the desired angle, and then
tighten the knob bolt firmly.
The vertical angle of the radiation disk is adjustable up
to 90 degrees.
Tighten
Loosen
Knob bolt
Radiation disk
Connecting the Power Supply
Do not use an adapter to change the power plug or power outlet from grounded (3 prongs or inlets)
to ungrounded (2 prongs or inlets) as this improperly overrides the safety function in grounding the
heater by means of the provided power plug. Also, if the power cord or plug needs to be replaced,
replace only with genuine or Shizuoka Seiki-approved replacement parts.
1. Make sure that the operating switch is “OFF” and then plug
the heater’s power plug into an approved, grounded, 3-wire
extension cord.
2. Plug extension cord into standard 120 volt/60 Hz, 3-prong
grounded outlet.
POINT:
Extension Cord Size Requirement
• 6 to 10 feet (1.8 to 3 meters) long, use 18 AWG (0.75 mm
2
)
rated cord
• 11 to 100 feet (3.3 to 30.5 meters) long, use 16 AWG (1.0
mm
2
) rated cord
AC Outlet
Extension Cord
Grounded Power Pin
Connect
