11
1. Disconnect the power lead from the back of the base unit
2. Press and hold the
HANDSET LOCATOR
button in the base unit, at the same time
connect the power lead into the back of base unit. Release the
LOCATOR
button after
you hear “beep” sound for five times. The IN USE light on base unit lights during this
whole process.
3. After 2~3 seconds, you can hear “beep” sound for two times again and the IN USE light
goes off;
4. Disconnect the power lead from base, and then connect it again, you will hear
confirmation tone from the base unit.
Handset registration
Your SD2100 is supplied with the handset already registered to the base unit, and you shouldn't
need to register it. But if you've bought extra handsets separately, you'll need to register each
one to your original base unit. Maximum 4 handsets can be registered to one base.
To register a handset
1. Press and hold the
Handset locator
button on the base unit for a while, until you hear
"beep" sound twice continuously.
2. Press
the
MENU
button, then press
UP/DOWN
button to the location
REGISTER
3. Press
the
OK
button, then press
UP/DOWN
button to the location
SUB BASE
4. Press
the
OK
button again
5. The display shows
BASE? 1 2 3 4
. Key in a base unit number
6. The display shows
selected number, then shows the ID of the base unit after
3~4 seconds.
7. Press
the
OK
button again
8. The display shows
PIN?
9. Key in your pin (default 0000) and press
OK
to confirm.
10. If the display says
NOT REG
, check to see if you key in the correct PIN, then repeat the
registration procedure again from step 1.
Intercom and transfer
To make an intercom call
1. Press
the
INT
button
2. Key in the number of the other handset
On the other handset's display, your number appears, and the
INT
symbol flashes. Then the
other handset user presses the
CALL
button to connect the call.
For details of how to change the ringing melody and volume for intercom calls, see "INT
MELODY" and "INT VOLUME" on "HANDSET SETTING" part.
To end an intercom call
Press the
CALL
button on your handset
The other person will hear Busy tone, and should also press the
CALL
button to hand up.
To transfer the outside call to another handset
(if you have two or more handsets)
:
•
Press the INT button and key in the number of the other handset.
•
The outside call is put on hold. When the other handset answers, you can speak to the
user. If the other handset does not answer, you can get back to the outside call by
pressing the INT button again.
To transfer the outside call to another outside phone:
•
Press the
Recall
button and key in the call number you want to transfer.
•
The first party is put on hold. When second party answers, you can speak to the user,
then press the
CALL
button to hang up and transfer the call.
Note : Network Dependant
