2. Secure door catch to inside of door approx.
centrally alongside the wood block using 2 x
25 mm screws.
3. Close the door and attach the door catch
together with the housing and mark the
required position of the door catch housing.
Secure using 2 x 25 mm screws.
4. Repeat for garage doors.
1. Secure the profiled fascia to front gable
end using 3 x 40 mm nails per piece.
Secure plain fascia to back gable using 3 x 40
mm nails per piece.
2. Trim off any excess felt with cutting knife
against edge of fascia board.
3. Fix diamond on top of and in the centre of
the fascia board using 2 x 40 mm nails per
diamond.
1. Remove protective film from both sides of
glazing material.
2. Place glazing material into the aperture of
each window.
3. Hold glazing in position with four pieces of
beading. Secure beading in position using 2 x
15 mm panel pins per piece of beading.
Repeat for all window apertures.
The beading may need to be swapped
around to get the best fit.
1. Push fit vents into the apertures of the back
panel.
1. Hold shutter in place and secure from the
inside using 4 x 25 mm screws, 2 into each
block. Repeat for other shutter.
J Fascia & Diamonds
K Glazing
L Vents
M Shutters
.
Assembly Completion Checklist
1
Check and ensure that no raised grain or splinters
are evident on timber components. Sand down any
raised grain or splinters using fine grade sandpaper.
2
Check that all screw, nail and pin heads are properly
tapped home and are not proud of the timber surface.
3
Check and ensure that no screws, nails or pins
protrude through any panel.
4 Check and ensure that all parts are properly secured
against reasonable force.
5
Do not apply decorative wood finish/treatments to wet
or damp timber. Please observe the instructions of
the wood finish/treatment manufacturer.
6
Adults need to check the playhouse regularly and
maintain the playhouse in good condition to provide a
safe environment. Do not use if damaged. If damaged
the playhouse should be properly and safely repaired
before further use by children.
