3 Secure to the back gable using 3x
40 mm nails into each gable.
Repeat.
4 Nail from outside into roof bearers
using 3x 40 mm nails for each roof
panel/bearer.
5 Nail through roof boarding into side
wall using 3x 40 mm nails per roof
panel.
6 Repeat for all roof panels.
7 At the front of the building under the
overhang fit two short bearers 'H3'
Ensure the bearers are flush with
the inside edges of the roof
sections and flush with the outside
edge of the front of the roof.
8 Fix in position from the outside
using 2x 60 mm screws for each
bearer. Secure together from the
inside using 2x 60 mm nails
9 Secure the front roof panels to the
front wall using 3x 40 mm nails in
each side.
1 Place the doors on a flat level
surface outside door edge up.
Check which side of the door the
hinges are to be fitted. The
diagonal door bracing should point
to the door opening. The hinges
are to be fitted on to the boarding
which covers each horizontal door
bracing.
2 Fit hinges to doors 'D & E'. The
long pointed part should be placed
on the door and the end of this part
should finish at the end of the door.
The round moveable part will be
overhanging the edge of the door.
Fit in place using 4x 25 mm screws
per hinge.
7 Place the padbolt in position on the
outside of the right hand door 'D'
directly over the central horizontal
brace. Ensure the edge is flush
with the upright edge. Secure using
4x 25 mm screws using the round
holes only.
6 The bottom bolt should fit flush with
the bottom edge of the door. Fit as
for top bolt.
5 Fit two bolts to the inside, inner
edge of the left door 'E'. The top
bolt should be positioned so that
the solid part of the bolt finishes
flush with the top of the door. Fit
using 4x 10 mm screws. Hold the
door tightly closed. Move the
moveable part of the bold and mark
where this meets the door frame.
Drill a small hole using an
8 mm drill bit.
3 To hang the doors two people are
needed - one to hold the door
square and level and the other to
attach the hinges on the wing
panels 'B1'. Start with the right
hand door 'D'. Place in the
aperture and check for level all
round. Fit 1x 25 mm screw in each
hinge first. Check for level, adjust if
necessary. Fit remaining 2x 25 mm
screws in each hinge. Repeat with
the left hand door 'E'.
4 Fit small door stop strips - pieces
B4. Fit flush to the inside edge of
the sides and top of the door
aperture. Nail in place using 18x 40
mm nails, 6 for each piece.
H
-
Door Assembly
Inside of door - for positions in relation
to bearers.
DO NOT FIT HINGES &
LOCKS ON INSIDE
