ETHERNET SERIAL INTERFACE CONNECT A PC OR CONTROL SYSTEM. VERSION COMPATIBLE V2.0
For a complete list of commands, please reference external document extended Ethernet Protocol Instruction Manual.
Example of command strings to select Inputs:
FUNCTION
COMMAND
VARIABLES
Select source
Source xxx;
xxx = Input Channel
(001=Source1, 002=Source2, etc.)
COMMAND
EXAMPLE RESPONSE
DESCRIPTION
Source 001;
Source 001#ok;
Select source number 1
ETHERNET SERIAL INTERFACE
Pin Ethernet Reference
1
TXOP
TX +
2
TXON
TX -
3
RXIP
RX +
4
NC
5
NC
6
RXIN
RX -
7
NC
8
GND
ETHERNET TCP/IP PROTOCOL COMMANDS ( ETHERNET / RS-232 CONTROL DRIVER V2.0.1 )
*** The Ethernet port and RS-232 port cannot be used simultaneously. Any connection to the Ethernet Control port will disable
serial commands send to the RS-232 port.***
RS-232 CONFIGURATION
RS-232 cable is a straight thru cable and not null-modem
Definition
Pin
Pin
Definition
1
1
DCD
TX
2
2
RX
RX
3
3
TX
4
4
DTR
GND
5
5
GND
6
6
DSR
7
7
RTS
8
8
CTS
9
9
RI
RS-232
RS-232 PROTOCOL COMMANDS (RS-232 CONTROL DRIVER V2.0.1)
The ShinybowUSA switcher can be controlled via the TCP/IP serial control port to allow for interfacing to a PC, or similar third party control
system.
The serial communication parameters are 9600 baud, 8 bit, No Parity and 1 stop bit - this is often referred to as 9600 8N1. When the unit
recognizes a complete command it will perform the requested action - there is no delimiter character required.
17
ETHERNET & RS-232 SERIAL INTERFACE
PC
Shinybow
Device
Note:
Control the switcher
SPD: Speed
LINK: Ethernet link
RJ-45 Female 8P-8 Connector
