49
11.10 Interval Output Function
This function outputs data at regular intervals. You can also output data time stamped. Set an
interval in Hour-Minute-Second format. To use the interval output function, enable it in Function1 to
[
] or [
].
* If it is desired to output time stamp data at the same time, refer to Section 11.7.
11.10.1 Set interval output
1 Call the interval function.
Press the Set key until the display indicates
[
]. The display indicates an interval
with the leftmost digit blinking.
2 Set an interval.
Press the Zero/Tare key to change the figure at the
blinking digit. Use the Function key to move the
blinking position to the right. If you press the
Function key while the rightmost digit is blinking, the
leftmost digit blinks.
(You can use the arrow keys instead. Refer to page
23.)
3 Save the settings, and go back to
measurement mode.
Press the Set key to return to measurement mode.
When you press the Print key before saving an
interval, the original interval is displayed.
If you press any key other than the Set key here,
the balance goes back to the measurement mode,
but the settings are not saved.
11.10.2 Start interval output
Press the Print key. The display indicates [
], and starts interval output.
A [
] blinks during interval output. A [
] lights up when data is output.
11.10.3
Stop interval output
Press the Print key. The display indicates [
], and the balance goes back to measurement
mode.
Caution:
1.
Note that data may not be output at exact intervals because output operation is interrupted
while Function1 or Function2 is displayed.
2. If [
] is displayed, the interval is set to zero. In this case, you should set an interval
again.
：
：
Continuous press
Set
Set