Shindaiwa LE230, Руководство владельца/оператора

Страница: 13 / 20

13
23054
23051
NOTE:
For extended shaft life, the flexible cable
should be reversed end-for-end during the
reinstallation process.
7. Insert the flexible shaft into the female
end of the gearcase pinion.
8. Install the gearcase on the shaft tube in
the reverse order of removal.
CAUTION!
The D-shaped shim washer must be
positioned with its flat edge toward the
shaft tube.
50-Hour Maintenance
Every 50 hours of operation
(more frequently in dusty or dirty condi-
tions):

Remove and clean the cylinder cover
and clean grass and dirt from the cylin-
der fins.

Remove the cutting attachment, holder
and the gear shaft collar. Remove the
filler plug from the side of the gearcase
and press new grease into the gearcase
until the old grease has been pushed
out. Use only lithium-base grease such
as Shindaiwa Gearcase Lubricant or
equivalent. See Figure 25.

Use a hooked wire to extract the fuel
filter from inside the fuel tank. Remove
and replace the filter element. Before
reinstalling the filter, inspect the
condition of the fuel line. If damage or
deterioration are noted, the unit should
be removed from service until it can be
inspected by a Shindaiwa-trained service
technician. See Figure 26.
Figure 26
Filter Element
Hooked
Wire
CAUTION!
Make sure you do not pierce the fuel
line with the end of the hooked wire,
the line is delicate and can be dam-
aged easily.
23052
Inspect the Gearcase Protector.
The metal gearcase protector (P/N 72958-
16210) is installed to protect the gearcase
flange from damage when working close to
sidewalks or other abrasive surfaces, and
should be routinely inspected for damage
or excessive wear. See Figure 29.
Lubricate the Flexible Shaft.
Lack of lubrication will cause rapid wear to
2. Remove the gearcase index screw.
3. Slide the gearcase and shield assembly
from the shaft tube.
4. Pull the flexible shaft from the shaft tube
assembly and clean the shaft thoroughly
in solvent and dry with a clean shop
towel.
5. Inspect the flexible shaft carefully and
replace if worn or damaged.
NOTE:
Always replace the liner if the flexible shaft is
being replaced.
6. Coat the entire length of the shaft with
Shindaiwa Premium Gearcase Lube (or
equivalent), and reinstall the shaft in the
shaft tube assembly.
Gearcase Index
Screw
Shaft
Tube
Flexible Shaft
Gearcase Protector
(P/N 72958-16210)
When replacing the protector, inspect to be
sure that both of the protector mounting
screws are firmly tightened and each screw
is locked in place with a nut as shown in
Figure 29.
Nut
Figure 27
Figure 429
Liner
Gearcase
Clamp
Screw
the flexible shaft and also to the shaft tube
liner, resulting in increased vibration and
greatly decreased service life. Remove and
lubricate the flexible shaft as follows: See
Figure 27.
1. Loosen the gearcase clamp screw.
23053
Flat
(toward
tube)
Shaft
Tube
Gearcase
Figure 28
D-shaped Shim
Washer
New
Grease
Figure 25
Old
Grease
Shaft
Bolt
Bolt
Guard
Holder
A
Holder
B
Output
Shaft Collar
Blade