Shindaiwa DH231, Руководство владельца/оператора

Страница: 14 / 24

14
Muffler
gasket
Muffler
Spark arrester screen
Top tail plate
Lower tail plate
Muffler gasket bolt
Muffler
cover
Muffler
cover bolts
Gasket plate
Plate
Muffler cover
screws
Muffler plate screws
Gaskets
135 - hour maintenance
WARNING!
Never operate the unit with
a damage or missing muffler or spark
arrester! Operating with a missing
or damaged spark arrester is a fire
hazard and could also damage your
hearing.
Maintenance (continued)
If the engine becomes sluggish and
low on power, check and clean the
spark arrester screen.
Loosen the knob of the spark plug 1.
cover and remove the cover.
Remove the spark plug lead from
2.
the spark plug.
Loosen the four 5 mm bolts located
3.
at the top of the recoil starter hous-
ing and remove the cover.
Loosen the 5 mm bolt located at the
4.
top of the cylinder cover and two
4 mm bolts located at the bottom
of the cylinder cover and remove
cover.
Loosen three 5 mm muffler cover
5.
bolts and remove the muffler cover.
Remove muffler gasket bolt.
6.
Loosen two 4 mm screws from the 7.
muffler cover.
Remove two 4 mm screws from the
8.
top tail plate and remove tail plate.
Remove the spark arrester screen 9.
and clean with a stiff bristle brush.
Remove the muffler from the engine
10.
and inspect the cylinder exhaust
port for carbon buildup.
Reassemble the muffler in the
11.
reverse order of disassembly
IMPORTANT!
If you note excessive carbon buildup,
consult your servicing dealer.
Locknut
Guide Bar
Cutter
Blades Shoulder Bolt
Washer
(should turn
freely)
Adjusting cutter blades
Cutting performance of your machine
depends a great deal on proper cutter
blade adjustment. Properly adjusted
blades will oscillate freely yet help pre-
vent binding of cut material between
blades. Adjust blades as follows:
Loosen all blade locknuts at least 1.
one full turn.
Tighten each blade shoulder bolt
2.
firmly, and then loosen the shoulder
bolts 1/4 to 1/2 turn.
Cutter blade adjustment
Working from the gearcase end, 3.
lock each bolt in place by firmly
tightening its locknut while prevent-
ing the shoulder bolt from turning.
When shoulder bolt adjustment is cor-
rect, there should be a gap of 0.25–
0.50 mm between the cutter blades
and the flat washers, and the flat
washer beneath each bolt head should
turn freely.
WARNING!
The cutter blades are very
sharp! Always wear gloves when
working around the cutter assembly .
CAUTION!
Operating the trimmer with worn
or improperly adjusted cutters will
reduce cutter performance and may
also damage your machine. Never
operate the machine with damaged or
worn cutters.