Shindaiwa DGK35FS, Руководство владельца и оператора, Страница: 46 / 52

43
(12) Elimination of excessive carbon in the exhaust system by extended light load
Accumulation of carbon (soot, unburned fuel) in the exhaust system could cause system
deteriorates or an engine fault occurs. To eliminate soot and unburned fuel, run the unit at
more than 70% of the rated output for about half an hour, until the exhaust gas become mostly
colorless. The carbon will be easier to be accumulated when the unit runs at less than 30% of
rated output.
< Note >

W
hen the unit runs at rated power suddenly, accumulation of carbon in the exhaust system might
cause back fire symptoms. Operate the generator starting from 50% of the rated output and then
increase load gradually after confirming exhaust gas become colorless. Do not carry flammable items
that are highly combustible near the generator.
WARNING : EXHAUST GAS POISONING
 Do not operate the generator in poorly ventilated areas such as an indoors or
tunnels, as the exhaust gas of the engine contains substances that are harmful to
human health.
 Do not direct exhaust fumes at bystanders or buildings.
WARNING : INJURY
 Always be sure to check that the breakers on load side and switches for any
equipment using the generator are at OFF before turning the breaker to ON. Also
be sure to advise personnel on the load side that power will be turned on before
operating the breaker.
 Close all doors and lock them during operation.
CAUTION : FIRE
 Do not carry flammable items (such as fuel, gas and paint) or items that are highly
combustible near the generator as the muffler, exhaust gas and other parts
become extremely hot.

Position this generator 3 ft. (1 m) or more from walls or other hindrances, and on a
level surface.
CAUTION : INJURY
 Do not operate the generator if it has been modified or any parts have been
removed.
 Position the generator on a level stable surface so that it cannot slide or move in
any manner.

Before starting operation, always be sure to turn off all switches of equipment being
used and all breakers to OFF.
Clean Every 250 hours