Shindaiwa DG50MK-P, Руководство владельца и оператора

Страница: 36 / 48

33
Spill Containment Separate/ Reassemble
Turn the 3way fuel valve lever to the “B” side.
Remove the wiring connector.
Remove the fuel hoses (supply and return sides).
Remove the four spill containment fixing bolts
(M12, 8 pieces).
< Note >
When removing the fuel hoses, hold the union joint fixed
using a spanner or similar tool.
Prepare a container to receive the fuel remaining in the
fuel piping that will flow out of the removed fuel piping.
Lift the generator, separate the spill containment and set the generator on a flat surface.
After cleaning and inspecting the inside of the spill containment, reassemble the spill
container with this generator by performing the above procedures in the reverse order.
Reassemble the fuel piping and wiring connector to their original positions.
Turn the 3way fuel valve lever to the “A” side.
< Note >
After reassembling, bleed air from the fuel system.
(Refer to section “ 9-2. Procedures during Operation ”.)
After reassembling, check that there is no fuel leakage.
Spill Containment Cleaning/Inspection
Use a high-pressure cleaner or similar equipment to
clean the inside of the spill containment.
After cleaning, allow water to accumulate and check
that the spill containment has no internal leakage.
Remove the drain plug (R1”) to drain the cleaning
water.
Check that there no rust has developed inside of the
spill containment. If rust has developed, remove the
rust and clean again.
After the procedures have been completed, apply sealant coating to the plug (R1”) or
wrap it in seal tape.
< Note >
If the fluid drained when cleaning the spill containment contains oil or grease, dispose of it
according to the related laws and regulations.
If the spill containment has a leak, contact the authorized distributor where the generator was
purchased.
5
1
1
2
3
6
7
2
3
4
5
4
8
Drain Plug (R1”)
Position A
Inlet port Return port
Position B