Shindaiwa DG20MK-P, Руководство владельца и оператора

Страница: 33 / 48

30
(2) Replacing the Oil Filter
First Time 50 hours
Thereafter Every 400 hours
Drain the engine oil. (Refer to section “(1) Engine Oil
Replacement” .)
Remove the oil filter using a filter wrench.
Spread a thin layer of oil on a new oil filter gasket.
Thread the oil filter by hand, and turn by hand (do not use a filter wrench) from when the
gasket contacts the seal surface until it is securely tightened.
Add engine oil to the generator.
Shortly after starting the engine, always be sure to check that there is no oil leaking
from the seal surface.
< Note >
Request the authorized distributor where the generator was purchased to perform this procedure
if you do not have a filter wrench.
Oil filter part no.: 16414-32432 (Kubota part no.)
(3) Air Filter Element Cleaning/Replacement
Clean 100 hours
Replace Every 400 hours
Remove the air cleaner clips and cleaner cap.
Remove the element.
Clean or replace the element. Replace by
performing the above procedures in reverse order.
< Note >
Always be sure to turn the cleaner cap in the direction
indicated by the arrow.
Replace the elements earlier if using in an excessively
dusty location.
Do not add oil as this generator uses a dry element.
Clear foreign material by pinching the vacuator valve once a week in normal operating conditions
or daily if operating in a location that is excessively dirty or dusty. Wipe away any dirt or moisture
that has adhered to the parts.
Never touch the elements for any reason except cleaning.
Element part no.: R1401-42271 (Kubota part no.)
Cleaning the air filter element
If dry dust is adhering : Blow compressed air from inside the element.
If carbon or oil is adhering : Replace with new parts.
1
1
2
3
Gasket
4
6
2
3
5
Vacuator Valve
Air Cleaner Cap
Air Filter Elements
Air Cleaner
Cap
Clip