Shindaiwa C243S, Руководство оператора

Страница: 32 / 160

30
Maintenance
Loading nylon line
1. Cut one piece of line to recommended length.
Œ
2.4 mm dia. - 3 m
2. Align arrows on top of knob with openings in eyelets.
3. Insert one end of nylon line into an eyelet, and push line
equal distance through nylon line cutting head.
4. Hold nylon line cutting head while turning knob clockwise to
wind line onto spool until about 13 cm of each line remains
exposed.
Long term storage
Whenever the unit will not be used for 30 days or longer, use the
following procedures to prepare it for storage.
Œ
Clean external parts thoroughly and apply a light coating of oil
to all metal surfaces.
Œ
Drain all the fuel from the carburettor and the fuel tank.
To remove the remaining fuel from the fuel lines and carburettor
and with the fuel drained from the fuel tank.
1. Prime the primer bulb until no more fuel is passing through.
2.
Start and run the engine until stops running.
3. Repeat steps 1 and 2 until the engine will no longer start.
Œ
Remove the spark plug and pour about 7 grams of 2-stroke
engine oil into the cylinder through the spark plug hole. Place
a clean cloth over the spark plug hole. Slowly pull the recoil
starter 2 or 3 times so oil will evenly coat the interior of the en-
gine. Reinstall the spark plug. (Do not connect the spark plug
cap. )
Œ
Before storing the unit, repair or replace any worn or damaged
parts.
1. Wear Indicators
IMPORTANT
When the wear indicators located at the bottom of the nylon
line cutting head are worn smooth, replacement of the cover or
the entire nylon line cutting head is required.
NOTE

All stored fuels should be stabilized with a fuel stabilizer
such as STA-BIL®.

Gasoline stored in the carburettor for extended periods can
cause hard starting, and could also lead to increased serv-
ice and maintenance costs.