8
New Grass Trimmer Cutting Attachment Shield
Assemble the Cutting Attachment
Shield to the Outer Tube.
Figure 5
Cutting Attach-
ment Shield
Outer
Tube
Socket-
Head Cap
Screw
Bracket
Shim
Clamp
Screw
Shim
Retaining
Nut
Cutting Attachment
Shield Mounting Plate
1. Choose the shims and shield mount-
ing plate hardware that matches your
model designation. See Contents List
for model references.
2. Take special care that the D-washer is
installed in the gearcase clamp. See
Figure 5.
3. Install the cutting attachment shield
mounting plate to the gearcase with
the clamp screw only finger tight at this
time. See Figure 5.
4. Insert the cutting attachment shield
between the outer tube and the cutting
attachment mounting plate. See Figure
5.
5. Fit the two shims and the bracket
over the outer tube and install the four
socket-head cap screws finger tight.
See Figure 5.
6. Tighten the gearcase clamp screw,
then install the washer and retaining
nut and tighten securely.
WARNING!
NEVER
operate the unit without
the cutting attachment shield
installed and tightly secured!
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket
head screws
.
7. Tighten the four socket-head cap
screws to secure the cutting at-
tachment shield.
TSU07
Make sure D-washer
is correctly installed.
D-Washer
