Shindaiwa 501SX, Руководство владельца/оператора

Страница: 18 / 136

18
Cutting instruction
General
In all circumstances the operation of the chain saw is a one-man job.
It is difficult at times to take care of your own safety, so don't assume the responsibility for a
helper as well.
After you have learned the basic techniques of using the saw, your best aid will be your own
good common sense.
The accepted way to hold the saw is to stand to the left of the saw with your left hand on the
front handle so you can operate the throttle trigger with your right index finger.
Before attempting to fell a tree, cut some small logs or limbs.
Be thoroughly familiar with the controls and the responses of the saw.
Start the engine, see that is running properly.
Squeeze the trigger to open the throttle wide open, then start the cut.
It is not necessary to press down hard to make the saw cut.
If the chain is properly sharpened, the cutting should be relatively effortless.
Pushing the saw too hard will slow the engine and cutting will actually be more difficult.
Some material may adversely affect the housing of your chain saw.
(Example: palm tree acid, fertilizer etc.)
To avoid housing deterioration carefully remove all packed saw dust around clutch and guide
bar area and wash with water.
DANGER
Do not let the nose or tip of the guide bar touch anything while engine is running to
avoid kickback.
IMPORTANT
Acids from decaying palm tree sap may corrode crankcase and oil tank housings made of
aluminium and magnesium alloys.
To minimize the chance of this occurring, make sure to follow the cleaning procedure listed
below.
Make sure to clean metal parts from palm sap immediately after use.

Remove sprocket cover.
Clean wood chips and sawdust from cover and engine crankcase.

Never use metal tools for cleaning which may scratch the metal paint and allow
corrosion to develop.

Clean sap accumulation from metal parts with cloth and warm water soap.

Rinse with clean water and dry metal surfaces.

Apply a light coating of engine or bar and chain oil to metal parts after they are cleaned.