23
Installing electrical parts
Installing cockpit peripheral components
(2) Disconnect the electric wire from the E-TUBE port.
* As shown in the figure, use part (A) of the TL-EW02 as a fulcrum, move the tool like a
lever, then disconnect the plug part. If there is limited space to insert the tool, lift the
TL-EW02 straight up and disconnect the electric wire.
(1)
(2)
(A)
Installing cockpit peripheral components
Refer to the “SHIMANO STEPS Cycle Computer and Switch Unit Parts Dealer's Manual.”
Installing the battery mount and parts
Refer to the “SHIMANO STEPS Special Battery and Battery Charger Parts Dealer's Manual.”
Installing the speed sensor
NOTICE
•
For details on the compatibility of the speed sensor and drive unit, refer to the
compatibility information (https://productinfo.shimano.com/#/com).
Generic type
For models: SM-DUE10 (SD50 type)
The generic type speed sensor can be installed regardless of the type of brake, such as rim
brake, roller brake, or coaster brake. Install the magnet unit on a spoke on the rear wheel.
1.
Temporarily install the magnet unit to the spoke.
(1) Hold the speed sensor in its installation position on the frame and determine the
installation location of the magnet unit. The center of the magnet unit should be
aligned with the tip of the Δ marking on the speed sensor.
