Shimano Steps BT-E6000, Руководство дилера

Страница: 29 / 57

Installing and wiring the drive unit
Adjustment of the chain tension
29
4
Tighten the lock ring by hand and attach
the Shimano original tool.
While holding the left crank, tighten the
lock ring in the direction shown in the
illustration.
(G) (H)
(G)
TL-FC32 / FC36
(H)
TL-FC38
TL-FC38
NOTE
If using a torque wrench, use TL-FC38
in combination with TL-FC33.
TL-FC33 TL-FC38
*
An impact wrench cannot be used.
The lock ring has a left hand thread.
Tightening torque:
35 - 45 N·m
{306 - 393 in. lbs.}
5
Insert the right crank arm attach the crank arm fixing bolt, and tighten it.
Finally, attach the crank arm cap.
Tightening torque:
35 - 50 N·m
{306 - 437 in. lbs.}
6
After installing the crank arm, turn the crank counterclockwise to make sure that the crank
rotates smoothly.
„
Adjustment of the chain tension
When using an internal geared hub, it is necessary to adjust the chain tension.
Set the chain in place and adjust the amount of
slack that is present in the chain when it is
pulled up and down.
Use a force of about 10 N and adjust the total
slack in the chain so that it is over 15 mm.