CHARGING BATTERY PACK
1. Remove the battery cover on the bottom of the
transmitter. Insert 1 “9V” battery into the
compartment and replace the battery cover.
2. Insert the antenna to the top of
the transmitter and screw in tightly.
3. Switch the power switch to the “ON”
position
REMOTE TRANSMITTER SET-UP
CAR SET-UP
Remove the battery cover on the bottom of the car.
Install the battery pack by connecting the
wire plug from the car to the wire plug on the
battery pack. Insert the battery pack into the
bottom of the car and replace the battery cover.
Switch the power switch on the bottom of the car to
the "ON" position.
Car: 1 x “9.6V” NiCd rechargeable battery pack (included)
Remote Transmitter: 1 x “9V” battery (included)
1 “9V” Battery
IMPORTANT: New Battery pack is not fully-charged. Charge fully before first use.
Connect the wire plug of the battery pack to the wire plug of the charger.
Plug the charger into a standard 110/120V electrical outlet.
Charge for approximately 8 hours for the first time.
Subsequent recharges may require only 4-6 hours.
Unplug the charger from the outlet and detach the wire plug connectors.
NOTE: Use the plastic connector to attach and detach the battery
to the charger. Never pull on the wires, as they may come loose
from the plug connectors.
BATTERY REQUIREMENTS:
Steering alignment lever
WARNING: This product contains no user serviceable parts. Never attempt to repair or disassemble the car, charger, or battery.
