IMPORTANT SAFETY INSTRUCTIONS
Please follow the instructions below so as not to damage the unit.
SHIFT LINE does not accept responsibility for any damage caused by not following these instructions.
When transporting or storing the unit at temperatures below 0 C, it is necessary to keep the unit at room temperature for at least 1 hour
before switching it on. When connecting the unit to other equipment, use cables specifically designed for this type of connection. Do not
use faulty or damaged cables.
DANGER! HIGH VOLTAGE!
DO NOT DISASSEMBLE THE UNIT ON YOUR OWN! DO NOT SWITCH ON AN OPENED-UP UNIT! DO NOT SWITCH ON
THE UNIT IF THE 12AX7 TUBE IS NOT INSTALLED.
CONNECTING AN EXTERNAL POWER SUPPLY ADAPTER:
Plug in the external power supply adapter only after assembling the whole signal chain! Before using the adapter, make sure that its body,
connecting cable and plug function properly and are not damaged. First, plug the adapter into an electric mains socket, then connect the
adapter’s low-voltage jack to the power supply input on the unit’s left side panel.
DISCONNECTING THE EXTERNAL POWER SUPPLY ADAPTER:
Unplug the external power supply adapter from the electric mains socket, then disconnect the adapter’s low-voltage jack from the power
supply input on the unit’s left side panel.
REPLACING THE TUBE:
Disconnect the unit from the power supply and wait at least 3 minutes. Remove the 4 screws holding the unit’s back panel. Take out the
buffer holding the tube in place. Remove the tube by gently rocking it from side to side; do not apply any extra force! Insert the new tube
(12AX7 or its analogue). Put the buffer back in its place. Close the back panel and secure it in place with the 4 screws.
SPECIFICATIONS:
Tube type:
12AX7
Memory card type:
microSD
IN:
6,3 mm, mono, unbalanced, -20 dB, 1 MOhm input impedance
THRU:
6,3 mm, mono, unbalanced, -20dB, 1 kOhm output
impedance
SEND:
6,3 mm, mono, unbalanced, -10dB, 1 kOhm output
impedance
RETURN:
6,3 mm, mono, unbalanced, -10dB, 1 MOhm input
impedance
OUT:
6,3 mm, mono, unbalanced, +20dB, 1 kOhm output
impedance
BALANCED OUT:
XLR, mono, balanced, +10dB, 1 kOhm output
impedance
AUX:
3,5 mm, stereo, unbalanced, 0dB, 10 kOhm input impedance
PHONES:
3,5 mm, stereo, unbalanced, +10dB, 10 Ohm output
impedance
POWER IN:
12v DC 650mA, negative tip, 2.1/5.5 mm diameter.
Use only regulated power supply units.
Dimensions (LxWxH):
122x102x55 mm (4.8x4x2.2”)
Unit weight:
480 g (1.06 lbs)
PSU weight:
120 g (0.26 lbs)
DELIVERY SET:
Olympic MkIIIS preamplifier;
12V DC 1000mA PSU with 4 changeable plugs;
User guide.
Содержание OLYMPIC MkIIIS
Страница 1: ...USER GUIDE ...
