IMPORTANT! PLEASE READ THE INSTRUCTION MANUAL CAREFULLY,
AND OPERATE CORRECTLY ACCORDING TO INSTRUCTION.
WARNING! NEVER ALLOW CLAMPS TO TOUCH TOGETHER OR CONTACT
THE SAME PIECE OF METAL.
◎
Do not charge the Jump Starter in dangerous places, such as near fuel, near
fire etc.
◎
Do not expose the Jump Starter to the sun, rain or snow.
◎
Do not place the Jump Starter in microwave oven, pressurized container or
vacuum chamber.
◎
Do not charge the Jump Starter with non-standard charger, use only specified
charger equipped with Jump Starter.
◎
Do not immerse the Jump Starter in water or rinse by water, no waterproof
design.
◎
Do not operate the jump starter if it has received a sharp blow, been dropped
or otherwise damaged in any way.
Charged by DC adaptor (Cigarette charger)
while driving
◎
Plug the DC adaptor into Jump starter's
charging port;
◎
Connect the DC adaptor to the vehicle’s
cigarette outlet, the
L
ED lights flash in the loop;
◎
Five LED lights on when the internal battery fully
charged, Jump Starter will stop charging circuit
automatically;
◎
Disconnect the DC adaptor from the cigarette
outlet, and then unplug the DC adaptor from the
Jump Starter.
MODEL:
HJMF4000-12
READ THE INSTRUCTION MANUAL COMPLETELY BEFORE USING THIS PRODUCT.
RETAIN THIS INSTRUCTION FOR FUTURE REFERENCE
INSTRUCTION MANUAL
SMART LITHIUM
SAFETY
GUARANTEED
LiFePO4
Lithium Jump Starter and DC Power Source
•
1
•
CONTENTS
1. WARNING
•
2
•
4
5
7
6
2
3
1
Product Feature
1.Jump Starter
2. High Power LED Light
3.15V/1A Input port
4. Battery Capacity Indicator
5. POWER/LIGHT Button
6. Jumpstart socket
7. USB DC 5V/2.1A Outlet
8. Waterproof Bag
9. AC charger
10.
DC adaptor(optional)
11. 5V USB/Micro USB Connector
(optional)
12. Jump Cable and Clamps
(with fuse)
2. PRODUCT FEATURE
•
3
•
NOTE
◎
Please wait for 10 mins if several fail attempts, then start the vehicle again.
◎
If the vehicle couldn’t be started within 5S, let the Jump Starter cool for 3 mins
before attempting to start the vehicle again, or you may damage the Jump
Starter.
◎
If the ambiance temperature is below -10
℃
, the cranking performance will
decrease sharply, the Jump Starter may not start the vehicle successfully. You
can try a few attempts to start for warm up the battery and then increase the
starting performance.
◎
If not successful, place the Jump Starter in a warmer area for a short time.
3. OPERATING INSTRUCTION
•
4
•
3.2 USING USB DC5V/2.1A OUTLET
The Jump Starter is a DC power source for all DC devices that are equipped with
a USB plug.
1. Press the <POWER/LIGHT> button to turn on the Jump Starter.
2
.
P
lug
the
USB
switch cable
into
the
USB
Outlet
.
3
.
P
lug
the other
end
(
Micro
USB) of the cable into your device
or
use
the
original
charging
cable
of
your
device. Turn device on, if necessary.
4
.
W
hen
finished
,
turn
off
the
device
(
if
necessary
)
and
unplug
the
device
.
5. Press the <POWER/LIGHT> for 3S to turn off the unit or wait for 30s then the
Jump Starter will shut down automatically.
6
.
R
echarge
the
Jump Starter immediately after unplugging the device.
NOTE
Electrical devices must be removed first, or the Jump Starter can not shut down
automatically.
3.3 USING HIGH POWER LIGHT
1. Press <POWER/LIGHT> button to turn on the Jump Starter.
2. Quick press <POWER/LIGHT> button to switch three different LED light
modes.
First: Highlight; Second: strobe; Third: SOS; Fourth: Off
3. Press <POWER/LIGHT> for 3S to turn off the Jump Starter.
4. CHARGING THE INTERNAL BATTERY
IMPORTANT! CHARGE IMMEDIATELY AFTER PURCHASE, AFTER EACH
USE AND EVERY 6 MONTHS, ALWAYS KEEP THE INTERNAL BATTERY
FULLY CHARGED.
Charged by AC charger
◎
Plug the AC charger into Jump Starter's
charging port;
◎
Connect the AC charger to a 100~240VAC
electrical wall outlet, the
L
ED lights flash in the
loop;
◎
Five LED lights on when the internal battery
fully charged, Jump Starter will stop charging
circuit automatically;
◎
Disconnect the AC charger from the AC outlet,
and then unplug the AC charger from the Jump
Starter.
PROBLEM
POSSIBLE
C
AUSE
R
EMEDIES
5. TROUBLESHOOTING
The vehicle can not be
jumpstarted
The device can not be powered
Can not turn on the Jump
Starter
1) Improper clamp connections
2) The switch cable and
connectors are defective
3) The internal battery capacity is
too low
4) The device of 12V to be
powered is over 120W
The internal battery capacity is
too low
1) Check and make sure the connections is correct
2) Check the internal battery capacity and recharge it if
necessary
3) Try starting serval times to
warm up the battery and then
the starting performance increase.
1) Check and make sure the connections are correct
2) Change a new switch cable and connectors
3) Check the internal battery capacity and recharge it if
necessary
4) Make sure the device to be powered is not over 120W
Check the internal battery capacity and recharge it if
necessary
6. MAINTENANCE AND CARE
Fuse Protection
Overcharge and
Overdischarge Protection
Against-reverse Plug
•
5
•
•
6
•
•
7
•
7. SPECIFICATION
Battery type
12
V
12
WH
Lithium I
r
on Battery
15V 1 A
and DC
/ .0 AC charger
adaptor (Cigarette charger)
Charger
USB
DC
5V 2.1A
(Max 2.5A)
Peak Amps: 200A
High Power LED
Light (
1W
)
12AWG/8
.58" (
21.8
cm)
5.6"
×3.1"×1.1" (
142mm*80mm*28mm)
0.7 bls(330g)
Size and length of
Jump Сable and Сlamps
Function
The dimension of
Jump Starter
Weight
The working
temperature
14
℉
~140
℉
(
-10
℃
-60
℃
)
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
9
11
8
10
12
◎
Do not attempt to disassemble, modify, knock and throw the product, please
contact your local distributor if the product has any problem.
◎
Never place the Jump Starter directly above battery being jumped
◎
Keep out of reach of Children.
1. WARNING .....................................................................................02~03
2. PRODUCT FEATURE ...........................................................................03
3. OPERATING INSTRUCTION ...........................................................04~05
3.1 JUMPSTART THE VEHICLE ................................................................04
3.2 USING USB DC5V/2.1A OUTLET .... .....................................................05
3.3 USING HIGH POWER LIGHT ...............................................................05
4. CHARGING THE INTERNAL BATTERY ..................................................05
5. TROUBLESHOOTING .........................................................................06
6. MAINTENANCE AND CARE ..................................................................0 6
7. SPECIFICATION .................................................................................07
www.skyrichbattery.com
Power by: Global Power Central Inc
Add: San Gabriel, CA 91776
RoHS
Please read this instruction manual completely
before using this product.
Retain this instruction sheet for future reference.
SHIDO Jumpstarters are distributed by DC AFAM NV, Belgium.
For more info about SHIDO lithium batteries, please visit www.shido-batteries.com
MODEL: MF4000-12
