ENGLISH
20
Adjusting the current channel level
• Each time these buttons are pressed, the
corresponding channel is selected as follows:
< >: Only when the digital signals from Dolby Digital or DTS
program sources are input, these levels can be
displayed.
• Depending on the speaker settings ("N (None or No)") and surround mode, etc., some channels cannot be
selected.
• When the SPEAKER button is set to off, only the Front Left and Front Right channels can be selected.
• The LFE level (DD and DTS) is applied after exiting the menu.
• After adjusting each channel level with test tone, adjust the channel levels either according to the program
sources or to suit your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s
memory ("CAL"), not into preset memory("REF 1", "REF 2").
• The LFE level can be adjusted within the range of
-10~0 dB and other channel levels within the range
of -15 ~ +15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower the
setting as neccessary.
• Then the memory mode ("CAL", etc.) is displayed for
several seconds.
• When the memory mode or channel level
disappears, press this button again.
1
.
Press the CHANNEL LEVEL button.
2
.
Select the desired channel.
3
.
Adjust the level of the selected channel as desired.
4
.
Repeat the above steps 2
and 3 to adjust each channel level.
