Sherwood PM-9901, Руководство по эксплуатации

Страница: 6 / 9

C O N T E N T S
6 4
A S S E M B L Y
1. Remove the main unit with the packing from the
box and take off the packing.
2. Set the 45-rpm adaptor on the main unit.
3. Insert the turntable platter onto the center spindle.
4. Set the slip mat on the platter.
5. Installation of cartridge:
When installing a cartridge, refer to the operating
instructions of that cartridge.
During installation, attach the stylus protector to
guard the stylus tip from damage.
(1) Connect the lead wires to the cartridge
terminals. The terminals of most cartridges are
color coded.
Connect each lead wire to the terminal of the
same color.
White (L+) .............…………….... Left
Blue (L-) ....……………............... Left channel-
Red (R+) ..…………................... Right
Green (R-) .......……………......... Right channel-
(2) Install the cartridge to the headshell and tighten
it with screws provided with the cartridge.
6. Insert the headshell into the front end of the
tonearm, then turn the lock nut clockwise with the
headshell firmly held horizontally.
7. Slide counterweight onto tonearm.
Twist it lightly and it will screw onto the rear shaft
of the tonearm.
8. Adjustment of horizontal zero (0) balance and
stylus pressure:
(a) Remove the stylus protector, do not touch the
stylus tip during the adjustment.
(b) Set the cueing lever to the lower position.
(c) Release the arm clamp and lift the tonearm from
the arm rest to free it.
(d) Rotate the counterweight until the tonearm is
approximately balanced horizontally (floats freely).
(e) Refasten the tonearm with the arm clamp.
( f ) Hold the counterweight stationary with one hand
and rotate only the stylus-pressure ring to bring
the number "0" of the ring into alignment with the
center line on the tonearm rear shaft.
(g) Rotate the counterweight clockwise until the scale
shows the value corresponding to the pressure of
the used stylus. The stylus pressure of the installed
pick-up system is 2 g. If you use a separate pick-up
system, please follow the manufacturer’s
i n s t r u c t i o n s .
9. Set the anti-skating control knob to the same value
as the stylus pressure.
10. Install the dust cover to the main unit.