Restore the Sensor (PIR Motion detector) to Factory Default Settings
Reset procedure will delete all information on the Z-Wave network and Z-Wave
controller or
Z-Wave Gateway, and restore the sensor to factory default settings.
1. Remove the device cover
2. Make sure the sensor is connected to power source.
3. Press the reset button for 10 seconds, LED will flash.
4. Release the button.
NOTE
When the PIR is being restored factory settings, please make sure power source is
connected.
Battery Usage Tips
Battery life of the contact sensor is approximately 2years at factory default settings.
The current battery level is displayed in the gateway. Red battery icon means the
battery needs replaced. In order to avoid tamper detection, while replacing the battery,
please disconnect the association of the contact sensor with other devices.
Note
Contact sensor is battery powered. Using batteries other than specified may result in
explosion. Dispose of properly, please observe environmental protection rules.
Advanced Configuration
The following information is for someone that has some experience in setting up a
Z-Wave system or someone that has computer software running a Z-Wave controller
or Z-Wave Gateway. Please get familiar with software of Z-Wave controller or
Z-Wave Gateway before getting started.
1.
Sensitivity Level Setting
This parameter defines the sensitivity of PIR detector, it is recommended to test the
detector with movements from a farthest end of the coverage area at first time of use.
If movements cannot be detected sensitively, simply adjust the sensitivity level with
this parameter. This parameter can be configured with the value of 1 through 4, where
1 means high sensitivity and 4 means lowest sensitivity.
Function:
Sensitivity Level Setting.
Parameter Number:
1.
Parameter Size:
1 Byte.
Available Settings
: 1 - 4.
