Shenzhen Hongdian Technologies H792x, Руководство пользователя

Страница: 81 / 129

H92x 3G/4G Router 7 FAQ
Version (2014-05-28) 7 -47
Parameter Details Option
Network The network address that flow into or
out QOS, the limited speed of object Full in destination address and
subnet mask
Manual input
Format1: A.B.C.D/Mask
Port The network interface of QOS Value area: 1-65535
You can not configure the port,
if not the configuration
represents all ports
Rate Transmission rate of the network
address settings
Value area
：
1
～
65535
Units ： Kbps
Ceil Rate In ensuring the basic rate and the spare
bandwidth, the maximum bandwidth of
the network address of the
communication can be obtained with
higher priority will be given priority
redundant bandwidth
Value area
：
1
～
65535
Units ： Kbps
Priority Set the precedence of the rules
Value area ： [1,30]
Step 6
Single click “save” icon to QOS setting.
QOS is mainly for the average of user priority assigned route or a bandwidth of Internet users. If the router is
connected with two subnets: 192.168.8.1/24 and 192.168.9.1/24, the router QOS can control the rate of these
two subnets; If the router's bandwidth is relatively well-off, the router can be based on two subnets redundant
bandwidth is first priority and high priority redundancy to meet the bandwidth, then meet low priority subnet
redundancy bandwidth.
---END
5.5.6 Dynamic Routing (Optional)
RIP configuration
RIP protocol (Routing Information Protocol) is the most widely IGP (Interior Gateway
Protocol) , it was designed for the same technology used in small networks, and therefore
adapt to most of the campus network and used in a continuous regional networks that the rate
change is not big, H792x 3G/4G Router supports RIP v2 protocol. For more complex
environments, generally do not use the RIP protocol.
Step 3 Log-on WEB GUI of H792x 3G/4G router.
Step 4
Click “Forward > RIP” to open “RIP” tab, as Figure 5-53.