3
402-0016-0
Pool Table Battery Disconnect Harness
402-0001-0
PC Board - Bayside DBA Pool Table
402-0006-0
Pool Table Electronic Meter
402-0017-0
20' Ret. Cord W/Mounting Hardware Male Pull Out Cord - Female Plug Fixed Cord
402-0018-0
SE-1-12S 1.5Amp Onboard Battery Maintainer Charger Fully Automatic
402-0020-0
Master Wire Harness-PC Board Power-Motor Power-DBA Power Electronic Meter
402-0019-0
Battery Charger / Rechargeable Battery / PC Power Connector Harness
Section-2: Battery Installation & Connection
Step-1:
Unlock the metal DBA door and remove the wooden cash box from its shipping location behind the
battery bungee cord. Place the wooden cash box behind the roll down quarter coin mechanism.
Step-2:
Remove the rechargeable 12volt battery from the push chute cash box and install it in the battery hold
down area securely fastening the battery in place using the bungee cord. (See Below Picture)
Step-3:
Connect the Battery Disconnect Harness to the PC Power / Battery Charger harness. Positive (red) to
(red) and negative (white) to (white). Once this has been completed the PC board should go through its test
sequence and the LCD should read (1.00 Per Game). The DBA should also go through its test sequence and
two green lights on the front of the DBA should flash four times.
Step-4:
Standing at the Ball Box End of the Bayside DBA pool table reach under the table and pullout the
retractable 110-volt power cord. Plug this power cord into the nearest grounded wall outlet to fully charge the
12volt rechargeable battery. Once the battery is fully charged the full automatic 12-volt charger will shut down
to make sure that the battery is not over charged. The Bayside DBA pool table is now ready for play.
402-0015-0
12V18AH Battery
210-0230-0
6”Bungee Cord
SP-DBX-0-00-05
Quarter Drop Cash
402-0016-0 Battery
Disconnect Harness
402-0019-0 PC Power /
Battery Charger Harness
