appliances through mobile phone, PC or home automation systems. Shelly® uses
WiFi to connect to the devices con
trolling it. They can be in the same WiFi network or they can use remote access
(through the Internet). Shelly® may work standalone, without being managed by a
home automation controller, in the local WiFi network, as well as through a cloud
service, from everywhere the User has Internet access. Shelly® has an integrated
web server, through which the User may adjust, control and monitor the Device.
Shelly® has two WiFi modes - Access Point (AP) and Client mode (CM). To
operate in Client Mode, a WiFi router must be located within the range of the
Device. Shelly® devices can communicate directly with other WiFi devices through
HTTP protocol .An API can be provided by the Manufacturer. Shelly® devices may
be available for monitor and control even if the User is outside the range of the
local WiFi network, as long as the WiFi router is connected to the Internet. The
cloud function could be used, which is activated through the web server of the
Device or through the settings in the Shelly Cloud mobile application. The User
can register and access Shelly Cloud, using either Android or iOS mobile
applications, or any internet browser and the web site:
https://my.Shelly.cloud/
.
Installation Instructions
⚠
CAUTION!
Danger of electrocution. Even when the device is turned off, it is
possible to have voltage across its clamps.
⚠
CAUTION!
Do not connect the Device to appliances exceeding the given max load!
⚠
CAUTION!
Before beginning the installation please read the accompanying
documentation carefully and completely. Failure to follow recommended
procedures could lead to malfunction, danger to your life or violation of the law.
Allterco Robotics is not responsible for any loss or damage in case of incorrect
installation or operation of this device.
⚠
CAUTION!
Use the Device only with power grid and appliances which comply with
all applicable regulations. Short circuit in the power grid or any appliance
connected to the Device may damage it.
⚠
CAUTION!
The Device may be connected to and may control electric circuits and
appliances only if they comply with the respective standards and safety norms.
Factory Reset
You can return your Shelly Plug to its Factory Settings by pressing and holding the
Button for 10 seconds. Upon successful factory reset Shelly’s WiFi LED will flash
Red/Blue.
Declaration of conformity
Hereby, Allterco Robotics EOOD declares that the radio equipment type Shelly Plug
S is in compliance with Directive 2014/53/EU, 2014/35/EU, 2004/108/ WE,
2011/65/UE. The full text of the EU declaration of conformity is available at the
following internet address
https://shelly.cloud/knowledge-base/devices/shelly-plug-s/
Manufacturer:
Allterco Robotics EOOD
Address:
Bulgaria, Sofia, 1407, 103 Cherni vrah Blvd.
Tel.:
+359 2 988 7435
E-mail:
Содержание Plug S
Страница 15: ......
