*Important Please Read*
*
When the unit is turned off, press, and hold the power button for 2 seconds to turn the unit on.
The unit will begin in the ultrasonic cleansing, EMS, and vibration mode.
*
When the power is already on, a short press to the mode button will switch to the next mode.
*
When the unit is on, a short press on the + and - keys will adjust the intensity. It goes up to
level 5 When you press a 6
th
time it will go back to level one.
*All modes include vibration to stimulate muscles. This is a good thing!! You can change the level
of vibration with the “intensity” button. EMS will also show up in all modes. You can shut off EMS
or change the power level of the EMS to any mode
by quickly pressing the on/off button. There are
5 levels of EMS. The sixth press will turn EMS off. A 7
th
press will turn it back on to level one.
*
There needs to be product on the face for all modes except cold.
*
When using this unit please be sure to place the head flat on the skin so the full surface area is
touching. There are sensors in the head and if the full surface area is not on the skin, the sensors
cannot do their job!
Explanation of Skin Enhancer Modes:
Ultrasonic Cleansing:
You can use ultrasonic cleansing mode with or without a cotton pad.
1. Put a damp cotton pad on head of unit as shown below. Apply cleanser to face. Using circular
movements around the face for 2 to 3 minutes, this mode can effectively clean the dirt from the
pores making the skin translucent.
Frequency of use: 2-3 times a week. Reduce to once a week
for sensitive skin.
2. Apply cleanser to face and use unit
without
cotton pad over the cleanser. Using circular
movements around the face for 2 to 3 minutes.
Remove the plastic ring on the Skin Enhancer head.
Place a cotton pad on the head and place plastic ring on top. If plastic ring is difficult to place over
on head, use a thinner cotton pad or gauze.
