INSTALLATIEHANDLEIDING – P16
VERSION 0129NM02INT01
INSTALLATION MANUAL – P16 |
P16
EN
FR
07ANM20INT0
1
1.1 PRODUCT DESCRIPTION &
INTENDED USE
Thank you for choosing a NewMotion Electric Vehicle
(EV) Charge Point.
This charge point is intended to charge the batteries within
EVs compatible with IEC-61851 MODE3 definition and
requirements. Dedicated EV specific plugs will need to be
utilised. No adaptors, conversion adaptors or extension
sets for cables are allowed to be used. EVs and cables
used with this charge point should always be undamaged
and in their original state.
1.2 SAFETY W CAUTION!
The electrical system must be voltage-free during the
entire installation procedure. Failing to do so can lead to
serious injury or even death. The installation procedure
must be carried out by a trained installer who works in
accordance with all relevant local laws and regulations.
Do not install in potentially explosive atmospheres and/
or zones with high electromagnetic radiation and/or in
flood-prone areas.
The charge point is connected to the electricity grid and
even if the equipment is switched off, hazardous voltag-
es may be present at the input terminals. Always switch
off the AC supply before starting any work on the charge
point and/or its installation. Do not carry out any work
in rainy conditions or when the humidity is above 95%.
The safety guidelines are intended to ensure correct in-
stallation and usage. Any failure to comply with the valid
safety guidelines or instructions provided in this manual
may result in fire, electrocution or severe injury.
The charge point is a product in Safety Class I and is
supplied with an earth terminal for protection purposes.
The AC input clamps must be fitted with an uninterruptible
earth for protection purposes. Ensure that the connection
cables are fitted with fuses and circuit breakers. Never
replace a protection component with another type. First
check the full installation to determine if that component
can be used with the existing installation components.
Before you switch on the charge point, check that the
available power source matches the configuration set-
tings of the product, as described in this manual.
Tripping of the RCD could be caused by an earth fault
or a defect relay. If, after resetting the RCD, the device
cannot be activated or immediately trips again; please
contact your installer.
1.3 LEGAL DISCLAIMER
This manual is created for you with care.
We however do not guarantee that all information is
complete, accurate and correct.
If you find any unclarities or mistakes in this installation
manual, or if you have any feedback or suggestions in
general about this manual, please inform us at
[email protected] and men-
tion the document version in the subject.
Please check our website
www.newmotion.com/fr_FR/assistance
for the latest version of this manual.
NewMotion strongly advises to have the product
installed by certified professionals. How the product
should be installed and used depends on local circum-
stances and local and national regulation, which are not
mentioned in our manual. NewMotion is not responsible
for any loss or damage whatsoever caused – including
without limitation, any indirect, personal or consequen-
tial loss or damage – arising from or in connection with
the use of this manual. Nor does NewMotion accept any
liability for any such loss or damage arising out of your
reliance on any information contained in this manual.
1.4 CHARGE POINT OPERATION
In case of an error or issue, please contact NewMotion
for support.
1. INTRODUCTION
