Shel lab SVAC9-2, Инструкция по установке и эксплуатации, Страница: 13 / 46

13 | P a g e
INSTALLATION
H
ARDWIRE
R
EQUIREMENT
The oven requires permanent connect wiring (commonly known as hardwiring). Wiring to the power
source must be performed by a qualified electrical technician. All other Installation steps may be
performed by the end user.
I
NSTALLATION
C
HECKLIST
Carry out the procedures and steps listed below to install the oven in a new workspace location and
prepare it for use. All procedures are found in the Installation section of this manual.
Pre-Installation

Check that the required ambient condition for the oven are met, page Error!
Bookmark not defined. .

Check that the spacing clearance requirements are met, page 14.
•
Unit dimensions may be found on page 39.

Check that a suitable permanent connect electrical power supply is present, page 15.
Install the Oven in a suitable workspace location

Review the lifting and handling instructions, page 16.

Make sure the oven is level, page 17.

Install the oven in its workspace location, page 17.
•
A qualified technician may now wire the oven to its power source.
Set up the Oven for use
 Clean the oven chamber and shelving if needed, page 17
 Install the shelving in the oven chamber, page 18
 Connect the vacuum supply to the oven, page 19