1. Keep the motor drive and clipping heads clean. It is
recommended that you remove the blades after use and
clean them thoroughly.
2. Lubricate the heads and blade cutting surfaces while in use
and after use.
3. Keep the air filter free of hair and dirt.
4. Keep blades, comb and cutter sharp for maximum efficiency
and long life.
PROFESSIONAL CLIPPER BLADE CARE
Lengthens the Life of Clipper Blade Sets
1. Before you start clipping, apply a thin film of clipper oil to the
matting faces of the cutting blades and tension spring guide.
2. If you have new blades that do not seem to cut right, it may
be that the factory-applied preservative used to inhibit rust
has congealed. To remedy this, with the clipper running,
submerge only the cutting blades in specialised Blade Wash.
Wipe the outside surface of the blades dry with a clean dry
cloth and begin clipping again.
3. During the time you are clipping, use coolant occasionally.
The primary benefit will be to cool the cutting blades and
provide some lubrication.
4. If during the clipping operation you find the blade starts to
"drag" or "streak", it could be that hair has accumulated
between the upper and lower blades. To remedy this, with
the clipper running, submerge the cutting blades in blade
wash. Wipe the outside surface of the blades dry with a
clean dry cloth and begin clipping again.
5. If after submerging in blade wash and if your blade is still not
cutting properly, it is possible that very fine hair did not wash
out from between the blades. If this is the case, remove the
6
MAINTENANCE
FOR BEST RESULTS
Содержание STALLION 300
Страница 2: ...2 COMPONENT NAMES...
