Shaver SC-30H, Руководство по эксплуатации и запасным частям

Страница: 8 / 20

8
Shaver Manufacturing Company
www.shavermfg.com 712-859-3293
Operation (continued)
WARNING
For Models SC-30H, put the skid loader
into park or neutral and set the brake
before engaging the hydraulics .
Do not operate on steep slopes . Do not stop,
start, change directions suddenly, or use
excessive speed on steep slopes .
Look in ALL directions to make sure the area is
clear and safe before operating the equipment .
Maintenance
WARNING
Service and maintenance work not covered in
OWNER SERVICE must be done by a qualified
dealership . Special skills, tools, and safety
procedures may be required . Failure to follow these
instructions can result in serious injury or death .
Before you or the dealer performs
service or maintenance, lower the
equipment to the ground and
block securely . Turn the engine off and remove the
key . On SC-30H, disconnect the two hydraulic hoses
from the skid loader .
Before servicing, make sure the unit is properly
attached to the tractor .
Keep all persons away from the operator
control area while performing adjustments,
service, or maintenance .
Never perform service or maintenance with the
engine running .
Do not modify or alter, or permit anyone else to
modify or alter, the equipment or any of its
components in any way . This will void the
warranty .
Do not allow bystanders in the area when
operating or servicing the equipment .
After servicing, make sure the shields and
guards are properly reinstalled and in good
condition . Replace if damaged .
SAFETY
INSTRUCTIONS
Tighten all bolts, nuts, and screws to torque
chart specifications in this manual .
Storage
WARNING
Block the equipment securely for storage .
Do not climb or lean on equipment stored on a
stand .
Keep children and bystanders away from the
storage area .
Specifications
SC-30H HYDRAULIC STUMPBUSTER
Description Specification
Weight 650 lbs
Cutting Wheel Diameter 24 inches
Cutting Wheel Speed 1200 rpm
Hub Torque 140 ft lbs
Required Power Source 16 Min. - 30 GPM
Cutting Teeth
23
carbide steel teeth
Maximum Cutting Depth 10 inches