Sharper Image FLY 01, Руководство пользователя

Страница: 8 / 29

15 English
14 English
Your fan remote includes 1 coin style 3V CR2032 battery. Battery comes pre-
installed. Remove battery pull tab before first use.
1. For battery replacement, the remote requires one coin style 3V CR2032
battery. Always use the correct size and grade of battery for this product.
2. To replace battery, open battery door on the back side of the remote control
(you will need to loosen the small screw on door using a #1 Phillips screwdriver).
If necessary, clean the battery contacts and also those of the device prior to
battery installation. Remove any plastic protection from the battery and place it
in the remote with the + side facing out. Ensure the battery is installed correctly
with regard to polarity. Replace the battery door and screw.
NOTE: Remove batteries from the remote control when not in use for an extended
period of time and always remove dead batteries immediately and replace with
fresh. Do not store dead batteries in remote.
You will need to pair your remote to your fan. To pair remote, follow these steps:
1. Press ( ) on the product to turn fan on.
2. Remove pull tab completely from the remote.
3. Press and hold ( ) on the remote for 5 seconds.
4. Press any button on remote to confirm remote has been paired successfully.
NOTE: You should only need to pair your fan and remote with the first use of your
product. If, for some reason, the remote loses its connection, repeat steps 1-4
above.
REMOTE CONTROL
SETUP
REMOTE CONTROL
BATTERY REPLACEMENT
WARNING: This product contains a button battery. If swallowed, it could
cause severe injury or death in just 2 hours. Seek medical attention immediately.