37
Operation Buttons
Setting up GyroRemote
TEACH/LEARN
• Each GyroRemote has its own ID code, which must be recognized by the projector that is going to be used.
• The projector only recognizes the signal of the GyroRemote whose ID code has been input. Signals from other
projectors or GyroRemotes that may be operating in the same area are not allowed to interrupt each other.
Projector
GyroRemote
On-screen Display
1
Press
LEARN
on the projector.
2
While “Do you want to LEARN?” is displaying, press
ENTER
. You are now in LEARN mode.
CAUTION
• Entering LEARN mode erases all previously registered
GyroRemotes data. You must re-enter each GyroRemote ID code
in order for the projector to recognise them again.
3
Press
TEACH
located on the front, inside the upper
cover on the remote within 5 minutes. “Register” will
appear on the display and you can now start using
the GyroRemote with the projector.
4
To exit from the LEARN mode, press
LEARN
.
TEACH
LEARN
ENTER
Operating multiple projectors with one
GyroRemote
CAUTION
• Be aware that you can operate multiple projectors with one
GyroRemote, even if you are in another room, as long as you stay
within a 30 m range of the projector.
• LEARN mode will exit if the
LEARN
is pressed or 5 minutes has
elapsed.
1
Set projector to LEARN mode.
2
Press
TEACH
on the GyroRemote. You can now
operate multiple projectors with one GyroRemote.
3
Perform steps 1 and 2 for each projector you plan to
use.
4
To exit from LEARN mode, press
LEARN
.
• For setting multiple units in LEARN mode at one time, perform step
1 above for all projectors.
• When a GyroRemote is registered with more than one projector,
you can operate the screen pointer and other tools on all projectors
at the same time. However, depending on RF conditions in the
area, pointer positions may vary slightly between projectors.
Using multiple GyroRemotes to operate one
projector
One projector can recognize up to 8 GyroRemote ID
codes.
1
Set projector to LEARN mode.
2
Press
TEACH
on all GyroRemotes being used. Once
the eighth GyroRemote is registered to operate one
projector, the LEARN mode automatically finishes.
You can now operate one projector using multiple
GyroRemotes.
3
To exit from the LEARN mode, press
LEARN
.
• Contact your nearest Sharp Authorised LCD Projector Dealer or
Service Centre if you need to use an additional GyroRemote unit.
Содержание XG-P20XE
Страница 85: ...SHARP CORPORATION ...