Sharp ViewCam VL-NZ100S, Руководство по эксплуатации, Страница: 38 / 97

Basic Operations
Camera Recording
Basic Operations
23
Tape Playback
Available mode:
TAPE-VCR
The LCD monitor screen functions as a handy
playback monitor. Nothing needs to be
connected, allowing instant on-screen play-
back with the sound through the built-in
speaker.
1
Set the Media Selection
switch to TAPE.
2
Hold down the Lock button
and set the Power switch to
VCR.
3
Press
j
(or
k
) on the Operation button
to rewind (or fast forward) the tape to the
desired point.
4
Press
m
to begin playback.
Note:
• If you press the REC START/STOP button in
TAPE-VCR mode, the “ ” mark appears and
the camcorder enters Recording Standby mode.
If you do not intend to record, press
l
to turn
the “ ” mark off, then press
m
to begin
playback. This will ensure your previous
recording is not erased (see pages 49, 51).
Basic Operations
Playback
To stop playback
Press
l
.
To turn the power off
Set the Power switch to OFF without pressing
the Lock button.
Note:
• The tape is automatically rewound when
playback reaches the end of the tape.
Using Earphones
(Commercially
Available)
Available modes:
TAPE-VCR, TAPE-CAMERA
You can monitor the sound via stereo ear-
phones (commercially available) during
playback or recording. Stereo earphones with a
3.5 mm diameter plug can be used with this
camcorder.
Connect the plug of stereo earphones to the
PHONES jack on the camcorder as shown
below.
Notes:
• Before connecting stereo earphones, turn the
camcorder volume down to the lowest setting.
• The built-in speaker automatically turns off when
stereo earphones are connected to the PHONES
jack.
Lock button
Operation button
Media Selection switch
Power switch
PHONES jack