Sharp VC-H670X, Руководство по эксплуатации

Страница: 31 / 41

q
Intelligent Timer Recording (JUST REC)
When the tape is expected to run out halfway during timer recording (except for the Simple Recording Timer) in
the SP (standard play) mode, the mode will automatically change to the LP (long play) mode to prevent
termination of recording.
This
works only when JUST REC mode on the MODE selection screen is set to ON.
For example:
l
When a programme is timer-recorded with a tape while the automatic select is set to LP
mode as shown below.
About 60 minutes About 30
SP (standard play) mode LP (long play) mode
I
Total: 120
I
l
This function may not properly work for video tapes other than E-60, E-90, E-180 and E-240
l
This tape may not be completely used up.
l
When more than one programme is set on the timer, the automatic recording will work for the length of each
set programme, but not for the total length of all programmes.
l
When the LP mode is initially used for a programme, if the tape is not long enough to record the entire length
of the programme, the programme will not be entirely recorded.
Audio Dubbing
This VCR allows you to add a narrative or background music to a pre-recorded tape.
l
The audio signal will be recorded on the mono (linear) track. The Hi-Fi tracks remain unchanged
Connect the audio source to the
AUDIO IN L-R terminals (or L
only) on the front of your VCR
(remember to select
If a microphone is
to be used,
connect to your
audio equipment.
Audio source
Connect the audio source to the AUDIO IN L-R terminals (or L terminal only) on the front of the VCR as
shown above. (The input terminals on the rear of the VCR cannot be used.)
Insert the pre-recorded tape into the VCR.
Press PLAY/x2 to view the recording.
Press PAUSE/STILL when you reach the point on the tape where you want to begin audio dubbing.
Press
and will be shown on the On Screen Display.)
Wait about 4 seconds and then press PAUSE/STILL to begin audio dubbing.
Press STOP to finish audio dubbing. will disappear from the On Screen Display.)
l
Do not press
CHANNEL (CH
during audio dubbing.
l
Because the audio signal is recorded on the mono (linear) track, any previous recording on this track will be erased
l
If the Auto Tracking function is used during audio dubbing, the recorded audio may be distorted. Wait about 4 seconds
before pressing
PAUSE/STILL
to begin audio dubbing in step
31