Sharp VC-H670X, Руководство по эксплуатации, Страница: 10 / 41

Adjusting the Video Channel
To view the output of your VCR on the television screen, you must select an unused channel on your TV and
tune it to the output of your VCR (factory preset to UHF channel 37).
Turn on the TV, select the AV channel or an unused channel on the TV, and turn on the power on the VCR.
(See page 5, item 3.)
Load a prerecorded tape into the VCR (not supplied).
If the erasure protection tab on the tape is removed, the VCR will automatically play back the tape.
Otherwise press PLAY/x 2.
Tune the selected channel on the TV until the picture from the VCR is displayed on the TV screen. (This TV
channel must be selected each time the VCR is used.)
l
If picture interference appears on the TV screen in step above, you can change the video channel (RF
output channel from the VCR) the following procedure. (If UHF channel 37 is an active broadcast channel in
your area, manually select a different channel (UHF 28 to UHF 69) (see below) and then retune your TV as
above.)
(A) Press STANDBY (LOW POWER) on the VCR, or VCR STANDBY (for or STANDBY (for
on the remote control. The VCR enters POWER STANDBY mode. (See page 5, item 2.)
(B) Keep pressing MENU for more than two seconds to light up the on the VCR display. (“VCR” is
displayed above
(C) Press VCR or button of
channel for use as the video channel, then press
on the remote control to manually select an unused
(D) Repeat steps to above using the newly selected video channel.
I
10