Sharp SDW6747GS, Руководство по установке

Страница: 7 / 12

7
STEP 10: LEVEL DISHWASHER
WARNING
Dishwasher must be level for proper dish rack
operation and wash performance.
• Place level on door and rack track inside the tub as shown to
check that the dishwasher is level.
Check Level
Front to Back
Check Level
Side to Side
• Level the dishwasher by adjusting the four leveling legs
individually.
Turn Legs
to Adjust
TIP:
Pull lower rack out, about halfway. Make sure the rack does
not roll forward or back into dishwasher. If the rack rolls in either
direction, the dishwasher must be leveled again.
• If the door hits the tub, the dishwasher is not installed correctly.
Adjust leveling legs to align door to tub.
INSTALLATION INSTRUCTIONS
STEP 8: SLIDE DISHWASHER PARTIALLY INTO
CABINET
DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.
DAMAGE WILL OCCUR.
• Slide dishwasher into the opening a few inches at a time.
• As you proceed, pull the drain hose through the opening under the
sink. Stop pushing when the dish washer is a few inches forward
of adjacent cabinetry.
• Make sure drain hose is not kinked under the dish washer and
there is no interference with the water line, wiring or any other
component.
STEP 9: POSITION DISHWASHER UNDER
COUNTERTOP
• Make sure that wires are secure under the dishwasher and not
pinched or in contact with door springs or other dishwasher
components.
TIP: Check tub insulation blanket, if equipped. It should be
positioned so it is not bunched up or interfering with door springs.
Check by opening and closing the door.
• Push dishwasher into cabinet. The front corners of the dishwasher
door should be flush with cabinet doors. Be careful not to dent
front panel with knees or damage countertop or cabinets with
dishwasher parts.